Bussmann 80 Amp House Service Cut-Out Fuse Link

Product Information

Before we can upgrade your fuse, you will need to ensure all of our electrical equipment including your meter, meter tails, fuse board and consumer tails are at the correct size to accommodate the additional load. If however, your electrical equipment such as your meter or meter tails are not the correct size we will need to book in another visit after they have been upgraded. Building on both the DT and DTM design strengths, the DTP connector line was developed to fill the need for higher amperage, multi-pin, inexpensive connectors. Most fuse carriers will say 100 amp on the side, this only refers to max amp for that carrier, not what's inside although, if you've had any work done in last 10 years on your meter, the correct fuse inside the carrier should be additionally labelled on the carrier.

Did you know, if you're installing an electric vehicle (EV) charger, solar panels or other low carbon technologies and need to upgrade your main fuse up to 100amps, your installer may have already done this for you? The DT connectors are used in harsh environment applications where even a small degradation in connection may be critical.Lawson Type MF fuse-links are for use in single or three-phase house service cut-outs or similar installations. You can request this service by registering or logging in to our self service portal which also allows you to submit multiple applications and track the progress of any existing applications. If your main electricity supply is linked to your neighbour's property we will need to re-plan the work with you and your neighbour.

This high-quality main switch fused unit is essential for anyone looking to maintain the safety and reliability of their electrical systems.

should be well enough, the DNO can't just upgrade everybody's fuse to 100amp, there are reasons for certain cutouts to be graded at 60, 80, or 100. However, upgrading from the 60 Amps to 100 Amps requires a larger service head as the 100 Amp fuse is a lot larger in physical size than the 60 or 80 Amp models. These 80 Amp / 80A ME80 / ME80A BS88-3 (BS1361) type 2a house service cut-out main fuses are used to protect an entire house. Building on the DT design strengths, the DTM connector line was developed to fill the need for lower amperage, multi- pin, inexpensive connectors.

DT Series Assortment Boxes Deutsch’s DT Series housings offer field proven reliability and rugged quality. We also offer Saturday AM and Saturday all day services which are available at the checkout for zone 0 addresses. Please check carefully that the wiring is capable of the intended load, and that the fuse is capable of protecting the wiring. My understanding is that the charge point installer has to do the calculation on what fuse is needed then you have to apply for that change by the DNO. Just wondering if incoming supply cable size has to be considered although I see plenty of 80a fuses used with this type of supply cable.Don’t worry, we will let you know if this is the case and advise you on the next steps, you can then decide if you want to go ahead with the work. From looking myself, fuse box and smart meter can both take up to 100amps and wiring from fuse box and smart meter are 16mm. The DEUTSCH DT series general purpose connectors will provide reliability and performance on the engine or transmission, under the hood, on the chassis, or in the cab. Prepare photos to attach with your applications (please only do this from a safe distance without touching any electrical equipment).

A range of switch disconnector fuses which are rated for on-load switching and provide isolation of the switched circuit.DEUTSCH DTP Series connectors are the solution for your power application requirements and can be used in harsh environment applications where even a small degradation in connection may be critical.