Do It Hot Pot 2 | Electric Melting Pot for Lead | Melts Lead Ingots Quickly | 4 Pound Capacity | Lead Melting Pot for Fishing Weight Molds & Bullet Casting Molds | Made in The USA

Product Information

Air trapped inside cavity: This can occur with a new, very tight mould. Test by placing a small piece of paper between the surfaces of the mould. A small corner of an adhesive label or gummed paper, like the seal on an envelope or corner of a postage stamp, will serve very well for this purpose by temporarily adhering to the moulds’ surface. The paper will not allow the mould to close absolutely tight, and this small gap will permit air to escape from the cavity. If complete castings are obtained, leave the paper in place until the mould is broken in (usually 100-200 castings) and then remove it. Pour a fine stream of lead directly into the cavity gate. Do not flood the sprue or fail to pour directly into the gate. There’s a 700-watt strength heat going on with the Lee Melter Furnace, along with the fact that it has excellent force capability. Primarily you can use it along with an electric arc furnace. It works great with 110 volts. Unfortunately, it’s not strong enough to melt iron. Indeed, it works very fast when put into the highest temperature. Pros

Your cleaned tools, clothes, and safety gear may still contain traces of lead. Store them in a sealed container in a garage or outdoor shed, away from pets and children.Beginners who are new to casting & melting can start with this lead melting hot pot. Moreover, it’s an updated version of the previous one. Hot pot 2 melts lead and pours it very smartly. As it runs from the electricity, you don’t need an additional burner. If for some reason parcels are required to be redirected then an additional charge might be levied (where applicable). Also if goods are refused or not called for a charge might also be incurred. This list is not a full and exhaustive list and other reasons may apply.

Never allow children or anyone who is pregnant to use your lead-contaminated tools or come near your workspace before you clean it. [16] X Trustworthy Source Centers for Disease Control and Prevention Main public health institute for the US, run by the Dept. of Health and Human Services Go to sourceMaking your own leads can be very satisfying and save you heaps of money. Here top Isle of Wight angler Shaun Graham takes you through the dos and don’ts of moulding your own leads. If you do not wish to do this, or your manual does not have the nescessary data for your needs, you can visit our Reloading Data Section for manufacturer advice. Use a chisel or flat-head screwdriver to scrape off any molten lead that spilled and hardened on the floor of your workspace. Times have changed, and technology has updated, and so did the melting pot. Traditionally to use bullet casting pots, users need to put a burn or any kind of heater to heat the metal. Natural fire can be effective, but it can be harmful as you can’t control the temperature. Instead, the lead will become unusable, ultimately wasting energy. Using a burner or electric mixer is more of a sustainable choice. Lee Lead Melting Pot 90949 is an excellent traditional pot where Do-It Molds Electric Lead Melting Pot 2 is a tough competitor. Electric mixing pots are controllable, but you’ll always need a power circuit to run them. In case you’re wondering, it’s maximum heating capabilities. The answer is it can go up to two thousand Fahrenheit. We would say it’s a fantastic choice for home casting and mixing, but it’s not up to the mark for the industrial level. Remember that it is not a self-heating pot, and you’ll need an extra burner for heating it. Pros